Title

Personal Protective Equipment (PPE) Donning and Doffing Guidelines for On-Site Animal Disease Outbreaks

(V2242, June 2024)
File
Publication File:
Summary

This publication explains donning and doffing procedures.

Lead Author
Lead Author:
Mary Keena, 线上赌博app Extension Livestock Environmental Management Specialist, Carrington Research Extension Center
Other Authors

Margo Kunz, DVM, North Dakota Assistant State Veterinarian, North Dakota Department of Agriculture

Kelli Maddock, DrPH, Senior Research Scholar, 线上赌博app Veterinary Diagnostic Laboratory

Availability
Availability:
Available in print from the 线上赌博app Distribution Center.

Contact your county 线上赌博app Extension office to request a printed copy.
线上赌博app staff can order copies online (login required).

Publication Sections

Table of Contents

Donning Procedures

Ideally, steps 1-3 are done while still in your vehicle. If this is not possible, then designate your line of separation and step across as you put on your second pair of boots or boot covers.

  1. Put on boot covers.
  2. Put on Tyvek suit.
  3. Put on second boots that can be disinfected and/or boot covers as you step out of the vehicle or step across the line of separation.
  4. Tape boot covers to Tyvek suit.
  5. Prepare (i.e., measure and cut/tear) tape that is long enough to fit around the wrists/gloves, legs/boot covers and zipper seam of Tyvek suit. Fold tabs at the end of the tape for easy removal.
  6. Tape zipper seam of the Tyvek suit.
  7. Put on first (inner) pair of gloves.
  8. Poke thumb hole through Tyvek suit.
  9. Put on second (outer) pair of gloves.
  10. Tape second pair of gloves to Tyvek suit. This helps hold the sleeves in place, protecting wrists from potential exposure.
  11. Put on eyewear.
  12. Put on headcover.
  13. Put on respiratory protection.
Step 8
Step 8
Step 8
Step 8
Step 9
Step 9

Doffing Procedures

Disposable PPE items may be discarded in a biohazardous waste bag or garbage bag.

  1. Remove tape from Tyvek suit zipper, boot covers and outer gloves. Discard.
  2. Unzip Tyvek suit zipper.
  3. Roll shoulders and bend over to remove Tyvek suit, inside out, from arms down, removing outer gloves as you go.
  4. Continue to remove Tyvek suit, inside out, and step out of outer boot covers. Roll the suit and boot covers into a ball with the contaminated outer side in the center. Handle only the clean inside of the garment. Discard.
  5. Remove and disinfect permanent or reusable eyewear and set across line of separation.
  6. Remove respiratory protection and discard or clean, whichever is appropriate.
  7. Remove headcover and discard.
  8. Remove boots or inner boot covers. Disinfect boots with spray if not using removeable boot covers. Lift foot, spray in the air and step across the line of separation. Repeat on the other foot.
  9. Close and spray the biohazardous waste
    bag or garbage bag with disinfectant. Place inside another bag, close and spray with disinfectant again.
  10. Discard the biohazardous waste bag or garbage bag in the dirty zone.
  11. If you must take your discard with you, spray
    the bag with disinfectant before putting it in
    your vehicle.
  12. Remove and discard the inner gloves.
  13. Wash your hands with warm, soapy water. If washing isn’t possible, wipe with alcohol wipes or use hand sanitizer.
  14. Make sure vehicle tires are free of organic debris and disinfect them before leaving the site.
  15. When possible, take vehicle through a car wash before going to a new site.

Videos of the donning and doffing procedures can be found at www.usdatraining.com/ppe/.

The 线上赌博app Extension does not endorse commercial products or companies even though reference may be made to tradenames, trademarks or service names.

Figure 4
Photo Credit:
线上赌博app Photo
Step 3